Journal of
Electrical and Electronics Engineering Research

  • Abbreviation: J. Electrical Electron. Eng. Res.
  • Language: English
  • ISSN: 2141-2367
  • DOI: 10.5897/JEEER
  • Start Year: 2009
  • Published Articles: 59

Full Length Research Paper

Rotor angle stability analysis of a distributed generator connected to distribution network

T. Ananthapadmanabha1*, A. D. Kulkarni1, ManojKumar Pujar2, H. Pradeep1 and S. Chetan1
1Department of Electrical and Electronics Engineering, National Institute of Engineering, Mysore, India. 2Gulbarga Electricity Supply Company (GESCOM), Bellary Division, India.
Email: [email protected]

  •  Accepted: 19 August 2010
  •  Published: 30 November 2010

Abstract

This paper describes the rotor angle stability analysis of a distributed generators connected to a 10 kv distribution network consisting of wind generators, microturbines, and CHP plants. The distribution network being modeled in Matlab/Simulink/Sim Power-system takes into account detailed dynamic models of the generators. Fault simulations at various locations are investigated. For the studied cases, the critical clearing times are calculated and the influence of the inertia on the CCT of DG’s is analyzed. Results obtained from several case studies are presented and discussed.

 

Key words: Distributed resources, distribution system, dynamic modeling, critical clearing time, rotor angle stability, power system protection.

Copyright © 2024 Author(s) retain the copyright of this article.

This article is published under the terms of the Creative Commons Attribution License 4.0

Back to Vol. 2 No. 5
Back to articles
  • Articles on Google by:
SUBSCRIBE TO RSS
SUBMIT MANUSCRIPT
CONFERENCES